| Table of Contents |
|---|
...
|
...
Installation
For the installation of the custo router you can either give the router a fixed IP-Address or use DHCP.
The fixed IP-Address or DHCP can be set onto the custo router. See attached picture, you need to add a HDMI monitor and a keyboard and mouse to the custo router.
Start the custo service center and open Langzeit-EKG
...
Open the Network connections form your control panel and go to the properties of the Ethernet 3 (Trendnet USB to LAN ) connector.
Choose properties and change the Internet Prptpcol Protocol Versoin 4 (TCP/IPv4) by double clicking on it.
Enter an unused private IP address for the Network, in our example I used 10.0.0.100 with a subnet mask 255.0.0.0 , make sure you safe the settings.
Choose a free IP address for the custo router and enter this in the custo router.( In our example we used 10.000.000.101 with the same subnet mask
Set the IP address in the service center from custo diagnostic
Restart the custo router and custo diagnostic. Make sure you setup custo diagnostic according the made setting in the custo router.
We have set custoRouterHostName to 10.0.0.101, the custoRouterPort to 8090 and the UseCustoRouter to true.
Trouble shooting
In some occasions you are not able to connect to the custo router immediately.
...