Introduction:
This article describes how to configure a Trainings Place with and without a training device.
A trainings place without training device with guard, serves purely for ECG monitoring and is referred to as telemetry.
Configuration Trainingsplace for Training with Trainings Devices
Conditions:
- Key-Options, see https://www.customed.de/docs/x/DQK
- set the Basic Settings from Device Trademill/Ergometer in custo diagnostic see https://www.customed.de/docs/x/4gC
- set the comRF Connection, see https://www.customed.de/docs/x/IgK
Configuration sequence:
Enter the Page Device Connection with Steps 1-3
next Step, Selction of Trainingsplaces
if there are more than 8 places, 2 Monitors must be used.
next Step, set "Type of exercises"
The most common setting is "Free exercies with Smart-Cards". It means that the patient selection takes place individually via the context menu on the Trainings Place main page.
With smart card means: if the ergometer has a chip card reader, the selection of the patient takes place by inserting the smart Card.
A detailed description of the types of exercise is here: https://www.customed.de/docs/x/H4CU
next Step
Selection of Trainingsplaces
Each training place must be configured separately.
By click on the button see arrow, it is possible to change from place to place.
Starting is always No. 1 and extends to the maximum set number, see Configuration Trainingsplace up to custo diagnostic
next Step
Assigning the Training Device with Equipment blood pressure, SPO2 and ECG amplifier from an ergometer to a training place
Selection of the ergometer
1: Click "Selection Exercise" 2: Selection of ergometers from the list of devices (see https://www.customed.de/docs/x/4gC) and Click "Save"
ecg:
1: Click "ECG" and 2: select "Exercice Device" and Click "Save"
SpO2:
1: Click "SPO2" and 2: select "Exercice Device" and Click "Save"
Blood Pressure:
does not have to be set, values are transferred automatically via the protocol
Assigning the Training Device with guard
Configuration comRF
Install Driver:
Variante 1
via Setup Selection, see
or Setup Command Line Parameters
Settings for comRF
Connect comRF to USB Port, and than configure the 1:1 Connection comRF to guard (as an Example, for 2 Trainingsplaces are needed 3 comRF Sticks)
Assigning guard
for fix Connection on the Trainingsplace:
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Telemetrie (pure ECG recording without training devices)
Trainingsplace without Trainings Device
